11s broken in compat wireless?

[杜尚鑫]

I m not sure about this but I am using x86 platform, the same problem as you got

On 2010年03月22日 (一) 9:05 下午 CST Marco Porsch wrote:

>Javier Cardona schrieb:
>> Hi Marco,
>>
>> On Thu, Mar 11, 2010 at 3:21 AM, Marco Porsch <marco.porsch at siemens.com> wrote:
>>   
>>> is it just me or is 11s broken in the latest compat-wireless?
>>> I tried with 2010-03-03 and an earlier release, in both versions Peering
>>> links do not establish (compat-wireless-2010-02-02 was fine).
>>>
>>> "iw <interfae> station dump" shows
>>>
>>> Station xx:xx:xx:xx:xx:xx (on mesh)
>>>    inactive time:    270 ms
>>>    rx bytes:    5019
>>>    rx packets:    157
>>>    tx bytes:    7614
>>>    tx packets:    135
>>>    signal:      -20 dBm
>>>    tx bitrate:    6.0 MBit/s
>>>    mesh llid:    0
>>>    mesh plid:    0
>>>    mesh plink:    LISTEN
>>>
>>> The plink status stays HOLDING, LISTEN or OPN_SNT, but does not reach ESTAB.
>>> Since no peering links are established, no further cummunication is
>>> possible (except for ARP).
>>> The mesh config should be fine, since it is the same script i used in
>>> earlier versions.
>>>     
>>
>> Did you upgrade all your mesh nodes to 2010-03-03 or just one?  I'm
>> trying to determine where to start troubleshooting this.
>>
>> Cheers,
>>
>> Javier
>>
>>   
>are there any news on this?
>Can someone confirm that this is a general problem or just OpenWrt 
>specific? Because I forgot to mention, I am using OpenWrt...
>_______________________________________________
>Devel mailing list
>Devel at lists.open80211s.org
>http://open80211s.com/mailman/listinfo/devel