11s broken in compat wireless?

[Marco Porsch]

Javier Cardona schrieb:
> Hi Marco,
>
> On Thu, Mar 11, 2010 at 3:21 AM, Marco Porsch <marco.porsch at siemens.com> wrote:
>   
>> is it just me or is 11s broken in the latest compat-wireless?
>> I tried with 2010-03-03 and an earlier release, in both versions Peering
>> links do not establish (compat-wireless-2010-02-02 was fine).
>>
>> "iw <interfae> station dump" shows
>>
>> Station xx:xx:xx:xx:xx:xx (on mesh)
>>    inactive time:    270 ms
>>    rx bytes:    5019
>>    rx packets:    157
>>    tx bytes:    7614
>>    tx packets:    135
>>    signal:      -20 dBm
>>    tx bitrate:    6.0 MBit/s
>>    mesh llid:    0
>>    mesh plid:    0
>>    mesh plink:    LISTEN
>>
>> The plink status stays HOLDING, LISTEN or OPN_SNT, but does not reach ESTAB.
>> Since no peering links are established, no further cummunication is
>> possible (except for ARP).
>> The mesh config should be fine, since it is the same script i used in
>> earlier versions.
>>     
>
> Did you upgrade all your mesh nodes to 2010-03-03 or just one?  I'm
> trying to determine where to start troubleshooting this.
>
> Cheers,
>
> Javier
>
>   
I tried both attempts. With all nodes on 2010-03-03 it did not work, and 
also a single node on 2010-03-03 could not peer with nodes using a 
functional version.

The functional nodes print:
[   47.240000] phy0: Allocated STA xx:xx:xx:xx:xx:xx
[   47.240000] phy0: Inserted STA xx:xx:xx:xx:xx:xx
[   48.300000] phy1: Allocated STA xx:xx:xx:xx:xx:xx
[   48.300000] phy1: Inserted STA xx:xx:xx:xx:xx:xx

as normal (using two phys and interfaces on all nodes).

Regards,
Marco