11s broken in compat wireless?

[Javier Cardona]

Hi Marco,

On Thu, Mar 11, 2010 at 3:21 AM, Marco Porsch <marco.porsch at siemens.com> wrote:
> is it just me or is 11s broken in the latest compat-wireless?
> I tried with 2010-03-03 and an earlier release, in both versions Peering
> links do not establish (compat-wireless-2010-02-02 was fine).
>
> "iw <interfae> station dump" shows
>
> Station xx:xx:xx:xx:xx:xx (on mesh)
>    inactive time:    270 ms
>    rx bytes:    5019
>    rx packets:    157
>    tx bytes:    7614
>    tx packets:    135
>    signal:      -20 dBm
>    tx bitrate:    6.0 MBit/s
>    mesh llid:    0
>    mesh plid:    0
>    mesh plink:    LISTEN
>
> The plink status stays HOLDING, LISTEN or OPN_SNT, but does not reach ESTAB.
> Since no peering links are established, no further cummunication is
> possible (except for ARP).
> The mesh config should be fine, since it is the same script i used in
> earlier versions.

Did you upgrade all your mesh nodes to 2010-03-03 or just one?  I'm
trying to determine where to start troubleshooting this.

Cheers,

Javier

-- 
Javier Cardona
cozybit Inc.
http://www.cozybit.com